danman
20-02-2011, 10:54 PM
Hoping someone here can point m in the right direction. Th eright rear on the Excel is not able to 'align up'. In order to get the toe I'm chasing I need to ave too much camber. So the setting on the roght is 0.7mm toe out but it has -3 camber. While teh left has 0.7mm toe out but only -1 camber.
If we try to even out the camber it increases the toe. I assume that there's something bent there (the arms look OK) but woudl be keen to get some thoughts on where to start.
If we try to even out the camber it increases the toe. I assume that there's something bent there (the arms look OK) but woudl be keen to get some thoughts on where to start.